Forum: Corse Technical

Does anyone has a front wheel from a 926? I would like to see such a wheel, without discs.

Does anyone know if the Corse 926 tanks should have the same size graphics as the road tanks or smaller?

Hallo, Can somebody please tell me what the width off the hub is on a rear racing/corse wheel. So just the wheel hub, not with the sprocket carrier...

Hi, Have any of you ever made this part to support the 851 tank ? Eric

Hi everyone, Is there someone on the forum that is able to help me out in my search for info about 888 racings in the Belgian Superbike series...

Does anyone have eproms 63 64 and 65 spare please. If so PM.

Hi to all, I'm looking informations or photos about 888 racing 93/94 with front forks different from Ohlins. For sure I see old photos of bikes...

Does anyone know where the power group connector covers can be bought please. They look triangular in shape with cable inlet at the pointy end ?

hello guys, i found some spare parts form a local deleader,and in this bits i found a complete set(spacer,bronze buching,rear brake plate and his...

Knowing that the race pick ups are Mercedes origin and hard to find, did some online searching .. sensor head seem to be plenty available, however...

Anyone know the part # for the small screws x4 which attach the cover to the ECU ? Thanks in anticipation

What’s the best front pads for race use ???? Getting one of the girls ready for next years Island Classic

Hi, is a racing steering stem for the magnesium yokes shorter than the strada/sp stem? I've got a set of alloy racing yokes and I'm messuring to...

Are all the 888/926/916/955 heads from the same basic casting with different machined inlet/exhaust porting and appropriate valve seats etc ??

Anyone had problems accessing this recently

Has anyone seen Casings or Cylinder Heads with DME stamped please ?

I’m after a source for breake hoses having a side mounted banjo.. this assembly has a hanging caliper and side mount like the smaller corse rear...

Finally picked up the tank outlet/reversion fittings I had made, not a cheap exercise but made to OEM Spec. If anyone is in need of a set PM me for...